Restart system
If the system is already running, turn off and restart the system to reset previous settings.
reset previous settings.
Start system
Turn on the system and wait for it to boot up.
The message below will be displayed. Select "Yes" or "No". (Projector can be turned on afterwards).
Control light
To control the light, select one of the presets. Preset 1 (stage light) is selected by default. If you want to switch on the disco ball chose preset 2
To make the disco ball rotate, switch to the expert mode and press the "DMX Timer" button. Press "DMX Timer" "Mirrorball ON", then switch back to basic mode.
Switch on the projector
lIf you did not switch on the projector at the beginning, switch it on on the left side. First, select a source in the Presentation window.
Here you can choose between Wireless or HDMI (Source 1).
Projector HDMI
If you decide to use HDMI, use the HDMI cable that is located in the room next door and connect it to the "IN 1" port.
Audio
In the "Audio" window, first select the audio destination. Here you can select the area where the audio should be played. Then select the audio source. You can adjust the volume in the lower left corner.
Microphone
To use one of the 4 microphones located in the metal cabinet underneath the bar, first select the audio destination here as well. Then select the microphone you want to use and take it out of the charger. If the light on the microphone is red, it is switched to "Mute". Press the mute key on the microphone to cancel the mute function.
